Tenda TEG5328P 24-410W L3 Managed POE Switch

Tenda, TEG5328P, 24-410W, L3 Managed, PoE, Switch,

Layer-3 Routing Engine，High-Efficiency Fast Forwarding:

Supports Layer 3 www routing protocols, supports Layer 3 forwarding of up to 400+ terminals, easily meets Layer 3 routing andforwarding across network segments, and truly achieves Layer 2 network isolation and Layer 3 network interworking. Comparedwith using a Layer 2 switch for transmission, there is no need to go through a router, and the forwarding speed is faster!

  370W Smart PoE Power Supply, 2 Times Load Capacity:

Using a new 410W built-in PoE power, the number of AF / AT full-supply loads is twice than the ordinary low-power PoE switches!At the same time, the built-in PSE chip with intelligent power management function can monitor the temperature of the chip and customize the PoE power supply based on the time period. The device will automatically turn on / off the PoE function during working hours and idle time to minimize energy consumption and extend the service life of the device.

Flexible QoS, Precise Traffic Control:

The TEG5328P-24-410W supports three QoS scheduling modes (SP, SWRR, WRR) for more accurate traffic control. After the QoS function is enabled, the traffic in the network will be precisely controlled according to the priority of the label. It will prioritize important traffic and reduce the proportion of data flows that occupy a large amount of insignificant traffic in the condition of limited bandwidth，in order to better meet the current transmission needs.

Supports Layer 2 And Layer 3 ACL，For More Secure Access:

Support strict access control based on MAC address or IP address, which can filter the corresponding data packets to enhance user network security. It can be used for network deployment of enterprise medical and other units.

Hardware:

Network standards:
IEEE802.3、 IEEE802.3u、 IEEE802.3ab、 IEEE802.3z、 IEEE802.3x、 IEEE802.3af/at、IEEE802.1p、IEEE802.1q、 IEEE802.1w、 IEEE802.1d、 IEEE802.1s

LED Indicator:
1*Link/Act or PoE LED indicator
1*Link/1*Link/Act mode converting LED indicator
1*PoE mode converting LED indicator
1*PoE Max LED indicator
1*Power LED indicator
1*SYS LED indicator

Interfaces:
24*10/100/1000 Base-T Ethernet ports
4*1000 Base-X SFP ports
1*Console port

Transmission media:
Recommended: CAT5/5e UTP or better

Fan quantity
2

Level of protection:
Lightning protection for ports: 6kV
Lightning protection for power: 6kV
ESD:
Air discharge: ±10kV
Contact discharge: ±8kV

Forwarding mode:
Store-and-forward

Switch capacity:
56Gbps

Packet forwarding rate:
41.70Mpps

Buffer:
12Mb

MAC address table:
16K

Jombo frame:
10K

PoE power supply management:
Support

PoE budget:
Single port: AF: 15.4W, AT: 30W
Whole device: 370W

Input voltage:
100-240V AC 50/60Hz

Power consumption
Full load: ＜432W
Empty load: ＜23W

Dimension:
440.0mmx284.0mmx44.0mm

Mounting:
Desktop mounting: support
Wall mounting: support
Rack mounting: non-support

Energy Efficient:
Support

Environment:
Operating temperature: 0°C - 45℃
Storage temperature: -40°C - 70°C
Operating humidity: (10% - 90%) RH, non-condensing
Storage humidity: (5% - 90%) RH, non-condensing

Certification:
FCC、CE、RoHS

Software:
L3 Features
Supports VLAN-based routing
Supports IPv4 static routing
Supports static ARP

PoE power supply management:
Supports port PoE configuration and power supply with priority
Supports PoE over-temperature protection
Supports PoE scheduled management
Supports intelligent management and PoE-powered device detection
(port status, power assignment and PoE-powered device status)

Security features:
ARP receiving limit
Unknown MAC address discard
DoS attack defense
802.1x security authentication
Radius security authentication

VLAN:
IEEE 802.1Q VLAN
VLAN Layer-3 interfaces
Supports three port modes: Access, Trunk and Hybrid

DHCP Server:
DHCP Relay
DHCP Snooping
Supports Option 82 policy configuration

Port aggregation
Static aggregation
LACP dynamic aggregation

Spanning tree:
IEEE 802.1d STP (Spanning Tree Protocol)
IEEE 802.1w RSTP (Rapid Spanning Tree Protocol)
IEEE 802.1s MSTP (Multiple Spanning Tree Protocol)
Supports edge port
Supports BPDU statistics

Multicast:
IGMP Snooping V1/V2/V3
Supports port fast leave

Port Mirroring:
Supports N: 1 port mirroring

Quality of Service:
SP (Strict Priority)
SWRR (Simple Weighted Round Robin)
WRR (Weighted Round Robin)
Supports 802.1p port trust mode
Supports DSCP port trust mode
Supports a maximum of 8-queue service quality mapping

ACL
Supports MAC ACL and IP ACL

Loading and upgrade:
Supports FTP/TFTP/HTTP upgrade
Supports configuration import and export

Management and maintenance
Supports Telnet, Console
Supports SNMP V1/V2/V3
Supports WEB management and maintenance
Supports Ping/Tracert/Connection Detection
CPU Monitoring and memory monitoring